Skip to content
Docs

Connecting to PQSC by Zurich Instruments in Python

Instrument Card

The Zurich Instruments PQSC Programmable Quantum System Controller brings together the instrumentation required for quantum computers with up to 100 qubits. Its ZSync low-latency, real-time communication links are designed specifically for quantum computing: the PQSC overcomes the practical limitations of traditional control methods, making automated and rapid qubit calibration routines a reality. Programming access to the powerful Xilinx UltraScale+ FPGA is the basis for developing new and optimized processing solutions for rapid tune-up and error correction adapted to the specific algorithm and computer architecture in use.

PQSC

Device Specification: here

Manufacturer card: ZURICH INSTRUMENTS

ZURICH INSTRUMENTS

Zurich Instruments Ltd. is a privately owned company developing and selling advanced test and measurement instruments equipped with software for dynamic signal analysis.

  • Headquarters: Switzerland
  • Yearly Revenue (millions, USD): 38
  • Vendor Website: here

Connect to the PQSC in Python

PROTOCOLS > SCPI

To connect to a PQSC Quantum Computing Control System using Qcodes, you can use the following Python script:

import qcodes as qc
from qcodes.instrument_drivers.zhinst import PQSC


# Connect to the PQSC instrument
pqsc = PQSC("pqsc", "dev1234")


# Print the instrument ID
print(pqsc.IDN())


# Arm the PQSC
pqsc.arm()


# Start sending out triggers
pqsc.run()


# Wait until trigger generation and feedback processing is done
pqsc.wait_done()


# Stop the trigger generation
pqsc.stop()


# Close the connection to the instrument
pqsc.close()

In this script, we import the necessary modules and create an instance of the PQSC instrument driver. We provide the instrument name (“pqsc”) and the instrument address (“dev1234”) as arguments to the PQSC constructor.

We then use various methods of the PQSC instrument to interact with the instrument. For example, we can use the arm() method to prepare the PQSC for triggering the instruments, the run() method to start sending out triggers, and the wait_done() method to wait until trigger generation and feedback processing is done.

Finally, we close the connection to the instrument using the close() method.

Note: Replace “dev1234” with the actual address of your PQSC instrument.